DODGE RAM 1998 2DR PICKUP
Security
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) DR. KICK PANEL "YEL PLUG"OR LIGHT SWITCH
TrunkTrigger N/A
FactoryAlarmDisarm LT.GRN/ORG(-) 24 PIN CONN BEHIND DR.DASH
ParkingLights BLK/YEL (+) (+) LARGE WHITE PLUG ABOVE BRAKE PEDAL
Remote Start
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense YEL (-) (-) IGNITION SWITCH HARNESS
NeutralSafety BLK/WHT (-) (-) IGNITION SWITCH HARNESS
Tach BLK/GRY (AC) PCM PASS REAR OF ENG ON FIREWALL SEE NOT
SpeedSense WHT/ORG 8000 (AC) POS 27 OF #2 PCM CONN
ParkingLights BLK/YEL (+) (+) LARGE WHITE PLUG ABOVE BRAKE PEDAL
BrakeLights WHT/TAN (+) (+) AT BRAKE SWITCH OR IGN. HARNESS
ReverseLights VIO/BLK (+) (+) 16 PIN GRY CONN DRIVERS DASH
Horn BLK/RED (-) 74 PIN CONN BEHIND DR. DASH
Doorlocks / Window
PowerUnLock PNK/VIO (REV) REVERSE POLARITY
PowerLock ORG/VIO (REV) 10 PIN CONN DR. KICK PANEL "
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT
LeftRearWindow01 LF:WHT
RightRearWindow01 RF:VIO/WHT
Convenience
HeadLights LT.GRN/BLK (+) AT STEERING COLUMN
LowSpeedWipers BRN/WHT (+) SWITCH
PICKUP
Mobile Audio / Video
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground N/A -
Illumination N/A
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORG
Amp BEHIND GLOVEBOX
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
