VII LINCOLN MARK 1988 2DR COUPE
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) COURTESY LIGHT UNDER DASH
TrunkTrigger BRN/WHT (-) (-) TRUNK SWITCH OR DRIVER'S KICK
HoodTrigger N/A
FactoryAlarmDisarm DK.GRN/PPL(-) DRIVERS KICK PANEL
ParkingLights BRN (+) LIGHT SWITCH OR DRIVER'S KICK PANEL
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) INGITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach DK.GRN/YEL(-) (-) AT COIL
ParkingLights BRN (+) LIGHT SWITCH OR DRIVER'S KICK PANEL
BrakeLights GRN (+) BRAKE SWITCH ABOVE BRAKE PEDAL
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) REVERSE POLARITY W/KEYLESS NEGATIVE TRIG
PowerLock PNK/YEL (-) DRIVER'S KICK PANEL OR BEHIND GLOVE BOX
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
TrunkRelease VIO/YEL (+) RELEASE SWITCH (POSITIVE) =NEGATIVE
COUPE
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) INGITION SWITCH HARNESS
Ground RED - (-) RADIO HARNESS
Illumination BLU/RED (+) RADIO HARNESS
Dimmer N/A
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORG/GRN
FrontLeftSpeakerNeg BLK/WHT
FrontRightSpeakerPos PNK/BLU
FrontRightSpeakerNeg BLACK/WHITE
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg BLU/ORN
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
