VIII LINCOLN MARK 1994 2DR COUPE
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/BLU (-) DRIVER'S KICK PANEL
TrunkTrigger WHT/VIO (-) (-) AT ANTI-THEFT MODULE "PASS KICK PANEL"
HoodTrigger N/A WORKS WITH TRUNK PIN SWITCH
FactoryAlarmDisarm DK.GRN/VIO(-) DRIVER'S KICK OR ANTI-THEFT MODULE
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK PANEL
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGN SW HAR"THIS IS A 2ND ACCESSORY WIRE"
Ignition03 +
Accessory01 GRY/YEL + (+) INGITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach TAN/YEL (-) (-) COIL ON ENGINE
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK PANEL
BrakeLights GRN (+) AT BRAKE SWITCH
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN(-) (-) NEGATIVE TRIGGER
PowerLock PNK/YEL (-) (-) DRIVER'S KICK PANEL
LeftFrontWindow01 LF=YEL
RightFrontWindow01 RF=WHT/YEL, AT SWITCH
LeftRearWindow01 LF=WHT/BLK
RightRearWindow01 RF=TAN/LT BLU, AT SWITCH
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
TrunkRelease VIO/YEL (+) DRIVER'S KICK PANEL
COUPE
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) INGITION SWITCH HARNESS
Ground RED - (-) RADIO HARNESS
Illumination BLU/RED (+) RADIO HARNESS
Dimmer N/A
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORG/GRN
FrontLeftSpeakerNeg BLK/WHT
FrontRightSpeakerPos WHT/GRN
FrontRightSpeakerNeg BLACK/WHITE
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg BLU/ORN
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/ORN
Amp TRUNK,UNDER DECK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
