PICKUP CHEVROLET S-10 2003 4DR PICKUP
Security
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PINK (+) IGNITION SWITCH HARNESS
Starter01 YELLOW (+) IGNITION SWITCH HARNESS
AllDoorTrigger BROWN/GRAY (-) DRIVERS KICK PANEL
ParkingLights LIGHT BLUE (+) AT VEHICLE LIGHT SWITCH
Remote Start
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PINK (+) IGNITION SWITCH HARNESS
Ignition02 ORANGE (+) IGNITION SWITCH HARNESS
Accessory01 BROWN (+) IGNITION SWITCH HARNESS
Starter01 YELLOW (+) IGNITION SWITCH HARNESS
AntiTheftType PASSLOCK II
AntiTheftSystem A RESISTANCE BASED SYSTEM
KeySense LIGHT GREEN (-) IGNITION SWITCH HARNESS
Tach WHITE (-) AT IGNITION COIL
SpeedSense GREEN/WHITE (AC) IN HARNESS ON PASSENGER SIDE OF ENGINE COMPARTMENT
ParkingLights LIGHT BLUE (+) AT VEHICLE LIGHT SWITCH
BrakeLights WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
ReverseLights GRAY (+) IN HARNESS TO TRANSMISSION
Doorlocks / Window
PowerUnLock WHITE (+) AT DOORLOCK RELAYS IN PASSENGER KICKPANEL
PowerLock LIGHT BLUE (+) AT DOORLOCK RELAYS IN PASSENGER KICKPANEL
DriverDoorMotor01 TAN (+)
DriverDoorMotor02 GRAY (+) AT VEHICLE FUSE PANEL
Convenience
HeadLights ORANGE (+) AT VEHICLE LIGHT SWITCH
LowSpeedWipers VIOLET (+) AT VEHICLE WIPER SWITCH
TrunkRelease BLACK (+) AT TRUNK RELEASE SWITCH
Mobile Audio / Video
Battery RED (+) IGNITION SWITCH HARNESS
Accessory01 BROWN (+) IGNITION SWITCH HARNESS
Ground BLACK (-) RADIO HARNESS
Illumination GRAY (+) RADIO HARNESS
Dimmer BROWN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRAY
FrontRightSpeakerPos LIGHT GREEN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BROWN
RearLeftSpeakerNeg YELLOW
RearRightSpeakerPos DARK BLUE
RearRightSpeakerNeg LIGHT BLUE
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
