MARQUIS MERCURY GRAND 1992 4DR SEDAN
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) DRIVER'S KICK PANEL
TrunkTrigger BRN/WHT(-) (-) LIGHT IN TRUNK
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach GRY/ORN (-) (-) AT EDIS MODULE "DRIVER'S FENDER"
SpeedSense GRY/BLK (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK
BrakeLights LT.GRN (+) AT BRAKE SWITCH
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) KEYLESS REVESES POLARITY SAME LOCATION
PowerLock PNK/YEL (-) BEHIND GLOVE BOX W/KEYLESS NEG TRIG W/OU
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
TrunkRelease PPL/YEL(+) (+) RELEASE SWITCH IN DASH
SEDAN
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ground -
Illumination BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORN/GRN
FrontLeftSpeakerNeg BLK/WHT
FrontRightSpeakerPos WHT/GRN
FrontRightSpeakerNeg BLACK/WHITE
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg PNK/BLU
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/ORN
Amp TRUNK, UNDER DECK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
