MARQUIS MERCURY GRAND 1990 4DR SEDAN
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) COURTESY LIGHT UNDER DASH
TrunkTrigger N/A
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach TAN/YEL (-) COIL ON TOP OF ENGINE
SpeedSense GRN/WHT (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVER'S KICK
BrakeLights LT.GRN (+) SWITCH ABOVE BRAKE PEDAL
Horn YEL/LT.GRN(-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) KEYLESS REVESES POLARITY SAME LOCATION
PowerLock PNK/YEL (-) BEHIND GLOVE BOX W/KEYLESS NEG TRIG W/OU
LeftFrontWindow01 LF-YEL
RightFrontWindow01 RF-WHT/YEL, AT SWITCH
LeftRearWindow01 LF-WHT/BLK
RightRearWindow01 LF-TAN/LTBLU, AT SWITCH
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
TrunkRelease VIO/YEL (+) DRIVER'S KICK PANEL
SEDAN
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ground -
Illumination BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/BLU (+) RADIO HARNESS
FrontLeftSpeakerPos ORN/GRN
FrontLeftSpeakerNeg BLK/WHT
FrontRightSpeakerPos WHT/GRN
FrontRightSpeakerNeg BLACK/WHITE
RearLeftSpeakerPos PNK/GRN
RearLeftSpeakerNeg PNK/BLU
RearRightSpeakerPos PNK/BLU
RearRightSpeakerNeg GRN/ORN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
