CAR LINCOLN TOWN 1992 4DR SEDAN
Security
Battery BRN + (+) IGNITION SWITCH HARNESS
Ignition BRN/PNK (+) IGNITION SWITCH HARNESS
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/BLU (-) PASS KICK PANEL OR BLK/ORN AT THEFT MOD
TrunkTrigger TAN/GRN (-) (-) AT ANTI-THEFT MODULE "PASS KICK PANEL"
HoodTrigger N/A WORKS WITH TRUNK PIN SWITCH
FactoryAlarmDisarm DK.GRN/VIO(-) DRIVER'S KICK OR ANTI-THEFT MODULE
ParkingLights BRN (+) DRIVER'S KICK PANEL
Remote Start
Battery BRN + (+) IGNITION SWITCH HARNESS
Ignition BRN/PNK (+) IGNITION SWITCH HARNESS
Ignition02 PNK/BLK + (+) IGN SW HAR"THIS IS A 2ND ACCESSORY WIRE"
Ignition03 +
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/PNK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach GRY/ORN (-) (-) AT EDIS MODULE "DRIVER'S SHOCK TOWER"
ParkingLights BRN (+) DRIVER'S KICK PANEL
BrakeLights GRN (+) AT BRAKE SWITCH
Horn DK.BLU (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) W/KEYLESS NEGATIVE TRIGGER SAME LOCATION
PowerLock PNK/YEL (-) BEHIND GLOVE BOX REVERSE POLARITY
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights GRY (+) AT LIGHT SWITCH
SEDAN
Mobile Audio / Video
Battery BRN + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/LT.GRN + (+) IGNITION SWITCH HARNESS
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination LT.BLU/RED (+) RADIO HARNESS
PowerAntenna ORG/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos FOR
FrontLeftSpeakerNeg INFO
FrontRightSpeakerPos SEE
RearLeftSpeakerPos FOR
RearLeftSpeakerNeg INFO
RearRightSpeakerPos SEE
RearRightSpeakerNeg TECH TIP
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
