CARLO CHEVROLET MONTE 1998 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger DK.BLU (-) (-) DRIVER'S KICK PANEL 20 PIN CONN
TrunkTrigger RED/BLK (-) (-) LIGHT IN TRUNK
ParkingLights BRN (+) (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 VIO + IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) IGNITION SWITCH HARNESS
Tach WHT (-) ELE. IGN MODULE
SpeedSense GRN/WHT (AC) PCM,PASS FENDER,BLU.80PIN PLUG,PIN A10
ParkingLights BRN (+) (+) AT LIGHT SWITCH
BrakeLights WHT (+) (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) SWITCH ABOVE BRAKE PEDAL
Horn BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL 20 PIN CONN
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO
Convenience
HeadLights YEL (+) (+) AT LIGHT SWITCH
TrunkRelease BLK (+) (+) TRUNK RELEASE SWITCH
COUPE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
