BLAZER CHEVROLET S-10 1997 4DR SUV
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (+) AT PIN SW BLK(-) AT K/LESS UNDER DRV DAS
TrunkTrigger RED WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 PNK/WHT + (+) IGNITION SWITCH HARNESS "SEE TECH TIP"
Ignition03 BRN + IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) 48 WAY CONN NEAR STEERING COLUMN
Tach WHT (-) (-) AT COIL
SpeedSense GRN/WHT (AC) PASS FRT QTR BLK 24 PIN CONN POS 3 OR PC
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights WHT (+) AT BRAKE SWITCH
ReverseLights GRY (+) (+) SWITCH ON TRANSMISSION
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (+) DRV DASH POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL OR K/LESS MOD UNDER
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT WIPER SWITCH
TrunkRelease BLK/WHT (+) OR RED AT SWITCH OR K/LESS MOD
SUV
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
