AVENUE CHRYSLER FIFTH 1990 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) DRIVER'S PIN SWITCH
TrunkTrigger BRN/BLK (-) (-) DRIVER'S KICK PANEL
HoodTrigger BRN/RED (-) (-) AT ANTI-THEFT MODULE ABOVE GLOVE BOX
FactoryAlarmDisarm LT.GRN/ORN(-) DRIVER'S KICK OR ANTI-THEFT MODULE
ParkingLights BLK/YEL (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BRN/YEL (-) SWITCH
Tach BLK/GRY (-) (-) AT COIL OR BLU/YEL(-)"V6" AT COIL PACK
SpeedSense WHT/ORG (AC) TRANSMISSION
ParkingLights BLK/YEL (+) AT LIGHT SWITCH
BrakeLights WHT/TAN (+) OR WHT AT BRAKE SWITCH
ReverseLights VIO(+) (+) SWITCH ON TRANSMISSION
Horn BLK/RED (-) AT FUSEBOX
Doorlocks / Window
PowerUnLock PNK/VIO (+) POSITIVE TRIGGER
PowerLock ORN/VIO (+) OR ORN/WHT DRIVER'S KICK PANEL
Convenience
HeadLights LT.GRN (+) AT LIGHT SWITCH
LowSpeedWipers RED/YEL (-) AND RED/YEL AT WIPER SWITCH "USE DIODE"
SEDAN
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg GRN/YEL
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg VIOLET/YELLOW
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg BRN/YEL
RearRightSpeakerPos BLU/RED
RearRightSpeakerNeg BRN/YEL
Amp UNDER RADIO
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
