2500 DODGE RAM 1995 2DR EXT CAB PICKUP
Security
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 DK.BLU/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) (-) DR. KICK PANEL "YEL PLUG"OR LIGHT SWITCH
TrunkTrigger N/A
FactoryAlarmDisarm LT.GRN/ORG(-) 24 PIN CONN BEHIND DR.DASH
ParkingLights BLK/YEL (+) (+) DR.KICK PANEL "YEL PLUG" OR NEXT TO COLU
Remote Start
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 DIESEL- + SEE NOTES
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 DK.BLU/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BLK/WHT (-) (-) IGNITION SWITCH HARNESS
Tach GRY/BLK (AC) COIL ON ENGINE
SpeedSense WHT/ORG 8000 3 PIN PLUG TRANS OR PCM RT SD DASH POS47
ParkingLights BLK/YEL (+) (+) DR.KICK PANEL "YEL PLUG" OR NEXT TO COLU
BrakeLights WHT/TAN (+) (+) AT BRAKE SWITCH OR IGN. HARNESS
ReverseLights VIO/BLK (+) (+) 16 PIN GRY CONN DRIVERS DASH
Horn BLK/RED (-) 74 PIN CONN BEHIND DR. DASH
Doorlocks / Window
PowerUnLock PNK/VIO (REV) REVERSE POLARITY DOOR LOCKS
PowerLock ORG/VIO (REV) 10 PIN CONN DR. KICK OR BEHND GLOVE BOX
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT
LeftRearWindow01 LF:WHT
RightRearWindow01 RF:VIO/WHT
Convenience
HeadLights LT.GRN (+) AT STEERING COLUMN
EXT CAB PICKUP
Mobile Audio / Video
Battery PNK/BLK + (+) OR RED IGN SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground N/A -
Illumination N/A
Dimmer ORG/WHT (-) RADIO HARNESS
PowerAntenna YEL (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg DARK BLUE/RED
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/LT.BLU
RearRightSpeakerPos DK.BLU/WHT
RearRightSpeakerNeg DK.BLU/ORG
Amp BEHIND GLOVEBOX
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
