2003 FORD FOCUS 4DR SEDAN
Security
Battery RED (+) IGNITION SWITCH HARNESS
Ignition GREEN/YELLOW (+) IGNITION SWITCH HARNESS
Starter01 GRAY/BLACK (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/BLU (-) DRIVER KICK PANEL
FrontLeftDoorTrigger BLK/YEL (-) DR. KICK PANEL
TrunkTrigger BLACK/BLUE (+) IN HARNESS IN DRIVERS KICKPANEL
FactoryAlarmDisarm BLK/WHT (-) DR. KICK PANEL
ParkingLights ORG/YEL (+) @ HEADLIGHT SWITCH
Security
LF Latch
MUST PULSE (-) TO THIS WIRE TO WAKE UP DOOR LOCK MODULE
Remote Start
Battery RED (+) IGNITION SWITCH HARNESS
Ignition GREEN/YELLOW (+) IGNITION SWITCH HARNESS
Accessory01 YEL (+) IGNITION SWITCH HARNESS
Starter01 GRAY/BLACK (+) IGNITION SWITCH HARNESS
AntiTheftType TRANSPONDER
AntiTheftSystem AN RF SIGNAL ACTIVATED SYSTEM
Tach BLK/ORG (AC) AT IGNITION COIL
ParkingLights ORG/YEL (+) @ HEADLIGHT SWITCH
BrakeLights GRN/RED (+) AT SWITCH ABOVE BRAKE PEDAL
ReverseLights GREEN/YELLOW (+) IN HARNESS IN DRIVERS KICKPANEL
Horn BLK/BLU (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock BLACK/YELLOW (-) IN HARNESS IN DRIVERS KICKPANEL
PowerLock BLACK/ORANGE (-) IN HARNESS IN DRIVERS KICKPANEL
DriverDoorMotor01 WHT/BLK REV DR. KICK PANEL
DriverDoorMotor02 YEL/BLK REV DR. KICK PANEL
PassengerDoorMotor01 WHT/BLK REV DR. KICK PANEL
Convenience
HeadLights LT. GRN/RED (+) AT HEADLIGHT SWITCH
TrunkRelease BLK/YEL (-) IN HARNESS IN DRIVERS KICKPANEL
Mobile Audio / Video
Battery RED (+) IGNITION SWITCH HARNESS
Accessory01 YEL (+) IGNITION SWITCH HARNESS
Ground BLACK/GREEN (-) RADIO HARNESS
FrontLeftSpeakerPos ORANGE/GREEN
FrontLeftSpeakerNeg BLUE/WHITE
FrontRightSpeakerPos TAN/GREEN
FrontRightSpeakerNeg GREEN/ORANGE
RearLeftSpeakerPos GRAY/BLUE
RearLeftSpeakerNeg BROWN/YELLOW
RearRightSpeakerPos BLACK/VIOLET
RearRightSpeakerNeg ORANGE/VIOLET
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
