2002 CADILLAC CATERA 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BRN (+) IGNITION SWITCH HARNESS
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRY (-) (+) IN DR.KICK OR AT BCM IS LOC. IN PASS KIC
TrunkTrigger BRN/WHT (-) (-) BODY CONTROL MODULE(PASS KICK)
FactoryAlarmDisarm BRN/VIO (-) BCM PASS KICK PANEL
FactoryAlarmArm BRN (-) BCM PASS KICK
ParkingLights GRY/GRN (+) (+) RIGHT OF STEERING COLUMN
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BRN (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 + HEAT AND A/C RUN OFF IGNITION
Accessory02 +
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem PASSKEY III
KeySense RED (+) (+) FUSE BOX
Tach GRN (AC) DRIVERS FRONT OF ENGINE ENG. CONTROL MO
ParkingLights GRY/GRN (+) (+) RIGHT OF STEERING COLUMN
BrakeLights YEL/BLU (+) (+) SWITCH ABOVE BRAKE PEDAL
Horn BRN/WHT (-) STEERING COLUMN HARNESS OR BCM
Doorlocks / Window
PowerUnLock BRN/PUR (-) GOLD DOTS,AT BCM PASS.KICK(ONLY 1DOOR)
PowerLock BRN/PUR (-) AND BLU DOTS,AT BCM PASS.KICK
LeftFrontWindow01 GRY/GRN
RightFrontWindow01 OR BLU/RED ALL DOORS
LeftRearWindow01 GRY/GRN
RightRearWindow01 OR BLU/RED ALL DOORS
Convenience
HeadLights YEL (+) (+) USE WIRE THAT TEST POSITIVE THERE ARE TW
LowSpeedWipers YEL (+) (+) WIPER WASHER SWITCH
TrunkRelease BRN/VIO (-) (-) TRUNK RELEASE SWITCH OR BCM
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 + HEAT AND A/C RUN OFF IGNITION
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
IN THE PASSENGERS KICK PANEL
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
