2002 BMW Z8 2DR CONVERTIBLE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) CONNECT ALL FOUR WIRES FOR PROPER START
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLU/RED (-) (-) AT DOMELIGHT
TrunkTrigger BRN/WHT (-) (-) AT HARNESS TO TRUNK
HoodTrigger VIO/GRN (-) (-) AT PIN
FactoryAlarmDisarm DISARMS WITH UNLOCK
FactoryAlarmArm ARMS WITH LOCK
ParkingLights BLK (-) (-) USE RELAY TO OPEN CIRCUIT TO PREVENT FDB
Security
Parking Lights
PLACE A DIODE BETWEEN SWITCH AND LIGHT WIRE TO PREVENT FEEDBACK
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition GRN (+) CONNECT ALL FOUR WIRES FOR PROPER START
Ignition02 +
Ignition03 +
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem EWS II
KeySense BRN/GRN (-) (-) IGNITION HARNESS
Tach BLK/YEL (AC) TACHOMETER
SpeedSense BRN/RED (AC) SPEEDOMETER
ParkingLights BLK (-) (-) USE RELAY TO OPEN CIRCUIT TO PREVENT FDB
BrakeLights BRN/GRY (+) (+) AT BRAKE SWITCH
ReverseLights BLU/YEL (+) AT SWITCH
Horn BRN/RED (+) IGNITION HARNESS
Doorlocks / Window
PowerUnLock BLK/WHT (+) (+) WHEN CAR IS RUNNING SEE NOTE*
PowerLock BLU/RED (+) (+) WIRES ARE IN DRIVERS DOOR WILL NOT WORK
Doorlocks / Windows
Power UnLock
WILL NOT UNLOCK WITH VEHICLE IGNITION ON
Convenience
HeadLights YEL (+) AT SWITCH
TrunkRelease GRY/BRN (-) (-) SWITCH IN DRIVERS KICK
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
PowerAntenna WHT (+) RADIO HARNESS
FrontLeftSpeakerPos YEL/RED
FrontLeftSpeakerNeg YEL/BRN
FrontRightSpeakerPos BLU/RED
FrontRightSpeakerNeg BLUE/BROWN
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
