2002 AUDI A4 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) DRIVER'S KICK PANEL BLU PLUG OR ALARM MO
TrunkTrigger WHT/BLK - (-) ABOVE DRIVER'S KICK " OR ANTI-THEFT MOD"
FactoryAlarmDisarm DISARMS WITH UNLOCK WIRE
FactoryAlarmArm ARMS WITH LOCK WIRE
ParkingLights GRY/BLK L + (+) GRY/RED R AT LIGHT SWITCH DIODE ISOLATE
Security
Parking Lights
ALSO (+) GRAY/RED-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 RED THIN + (+) IGNITION SWITCH HARNESS
Ignition03 BLU + SECOND STARTER WIRE MUST USE FOR REMOTE
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach GRY AC (AC) COIL ON ENGINE
SpeedSense WHT/BLU AC (AC) PIN A1 AT RADIO HARNESS
ParkingLights GRY/BLK L + (+) GRY/RED R AT LIGHT SWITCH DIODE ISOLATE
BrakeLights RED/BLK + (+) SWITCH ABOVE BRAKE PEDAL
Doorlocks / Window
PowerUnLock RED/BRN - (-) DRIVERS KICK PANEL *DOUBLE PULSE
PowerLock GRY/WHT - (-) DRIVERS KICK PANEL
Doorlocks / Windows
Power UnLock
REQUIRES DOUBLE PULSE
Convenience
HeadLights WHT/BLK + (+) AT LIGHT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU + (+) RADIO HARNESS
FrontLeftSpeakerPos BLU/WHT
FrontLeftSpeakerNeg BRN/WHT
FrontRightSpeakerPos RED
FrontRightSpeakerNeg BROWN/RED
RearLeftSpeakerPos BRN/WHT
RearLeftSpeakerNeg BLU/WHT
RearRightSpeakerPos BRN/RED
RearRightSpeakerNeg RED
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
