2001 DODGE CARAVAN MINIVAN
Security
Battery LT BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition PNK/WHT (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL/ORG (+) AT BCM 25 OF BK/GN
FrontLeftDoorTrigger VIOLET - PIN 6 OF BLACK/WHITE 34 PIN AT BCM
FrontRightDoorTrigger VIOLET/WHITE - PIN 7 OF BLACK/WHITE 34 PIN AT BCM
RearLeftDoorTrigger VIOLET/GRAY -
RearRightDoorTrigger TAN/ORANGE - PIN 5 OF BLACK/WHITE 34 PIN AT BCM
TrunkTrigger VIOLET ORANGE PIN 29 OF BLACK/WHITE 34 PIN AT BCM
HoodTrigger VIOLET/LT.BLUE - PIN 30 OF BLACK/WHITE 34 PIN AT BCM
FactoryAlarmDisarm VIOLET/LT.BLU 1.5 RESISTOR TO DISARM LOCK
FactoryAlarmArm VIOLET/LT.BLU 2.0 RESISTOR TO ARM LOCK
ParkingLights WHITE/BROWN - (+) @HDL SWTCH GRND,THROUGH 5.3 OHM RESISTOR
LowCurrent
ParkingLights N/A
Remote Start
Battery LT BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition PNK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 MULTIPLEXED RESISTOR VAL. UNKNOWN
Ignition03 MULTIPLEXED RESISTOR VAL. UNKNOWN
Accessory01 VIO/ORG + (+) IGNITION SWITCH HARNESS "16G WIRE"
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem TRANSPONDER
KeySense LT.BLU (-) IGNITION SWITCH HARNESS
Tach DRK.BLUE/GREE (AC) PIN 11 AT PCM LFT CORNER OF ENGINE COMP.
CrankShaftSensor BROWN/LT.BLUE - PIN 32 OF PCM LFT CORNER OF ENGINE COMP.
CamShaftSensor BLU/GRY - PIN 33 OF PCM LFT CORNER OF ENGINE COMP.
SpeedSense DRK.BLU/ORANG 66 OF PCM LFT CORNER OF ENG.COMP.2ND PLG
ParkingLights WHITE/BROWN - (+) @HDL SWTCH GRND,THROUGH 5.3 OHM RESISTOR
LowCurrent
ParkingLights N/A
BrakeLights WHITE/TAN + (+) AT BRAKE LIGHT SWITCH
ReverseLights WHITE/LT.GREE PIN 9 OF BLACK/GREEN 34 PIN AT BCM
Horn DRK.GRN/VIOLE STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock VIOLET/DRK.GR (-) PIN 21 AT BCM,GRND THROUGH 2K OHM RES.
PowerLock VIOLET/DRK.GR (-) PIN 21 AT BCM,GRND THROUGH 5.3K OHM RES.
ChildSafetyWire N/A
DriverDoorMotor01 TAN/LT.GREEN PIN 28 OF BLACK/GREEN 34 PIN AT BCM
DriverDoorMotor02 TAN/WHITE + PIN 10 OF BLACK/GREEN 34 PIN AT BCM
PassengerDoorMotor01 TAN/BROWN + PIN 26OF BLACK/GREEN 34 PIN AT BCM
LeftFrontWindow01 ORANGE/LT.GRN +
LeftFrontWindow02 ORANGE/WHITE + AT DRIVERS SWITCH
RightFrontWindow01 ORANGE/TAN + AT DRIVERS SWITCH
RightFrontWindow02 ORANGE/DRK.GRN + AT DRIVERS SWITCH
LeftRearWindow01 ORANGE/DRK.BLU + AT DRIVERS SWITCH
LeftRearWindow02 ORANGE/LT.BLUE + AT DRIVERS SWITCH
RightRearWindow01 ORANGE/GRAY + AT DRIVERS SWITCH
RightRearWindow02 ORANGE/DRK.GRN + AT DRIVERS SWITCH
Doorlocks / Windows
Power UnLock
USE 2KOHM RESISTOR
PowerLock
USE 4020 OHM RESISTOR WITH FACTORY ALARM/665 OHM WITHOUT
Convenience
FrontLeftParkLightBulb WHITE/BROWN +
FrontRightParkLightBulb WHITE/ORANGE +
RearLeftParkLightBulb WHITE/BROWN +
RearRightParkLightBulb WHITE/ORANGE +
HazardLights +
HazardFrontLeft WHITE/LT.GREEN + PIN 1 OF BLACK/GREEN 34 PIN AT BCM
HazardFrontRight WHITE/TAN + PIN 3 OF BLACK/GREEN 34 PIN AT BCM
HazardRearLeft WHITE/DRK.GRN + PIN 2 OF BLACK/GREEN 34 AT BCM
HazardRearRight WHITE/BROWN + PIN 4 OF BLACK/GREEN 34 AT BCM
LowSpeedWipers BROWN/WHITE + AT WIPER MOTOR
TrunkRelease TAN/YELLOW + PIN 26 OF BLACK/WHITE 34 PIN AT BCM
Mobile Audio / Video
Battery LT BLU/RED + (+) IGNITION SWITCH HARNESS
Accessory01 VIO/ORG + (+) IGNITION SWITCH HARNESS "16G WIRE"
Ground STRAP -
Illumination ORG/TAN + (+) RADIO HARNESS
AMPTurnOn GRAY/GREEN (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg GRN/BLK
FrontRightSpeakerPos GRY
FrontRightSpeakerNeg GRAY/BLACK
RearLeftSpeakerPos GRN/BLK
RearLeftSpeakerNeg GRN/ORG
RearRightSpeakerPos GRY/BLK
RearRightSpeakerNeg GRY/PNK
Amp LIMITED - ON SPEAKER
Control Modules
LOC. UNDER LFT SIDE OF INSTR. PANEL
ECM UNDER L/S (HOOD) INTELLIGENT POWER MODULE BCM UNDER L/S OF IP
PCM L/F CORNER OF ENGINE COMP.
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
