2001 CHEVROLET MALIBU 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) USE BOTH PINK WIRES
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger LT.GRN/BLK L (-) DRV KICK, LT.BLU(-) R DRIV KICK "ISOLATE
TrunkTrigger ORG/BLK - (-) TRUNK LIGHT
ParkingLights BRN + (+) AT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) USE BOTH PINK WIRES
Ignition02 DK.GRN + (+) IGNITION SWITCH HARNESS
Ignition03 BRN + IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK II
KeySense LT.GRN (-) STEERING COLUMN HARNESS
Tach VIO/WHT (-) TOP OF MOTOR AT COIL
SpeedSense GRN/WHT (AC) BLU 80 PIN POS13:BLK 24PIN POS16 DR KICK
ParkingLights BRN + (+) AT SWITCH
BrakeLights WHT + (+) AT SWITCH
ReverseLights LT.GRN + (+) 18 PIN CONN BEHIND DRIVERS DASH
Horn BLK - STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT - (-) DRIVERS KICK PANEL 1500 OHM
PowerLock WHT - (-) DRIVERS KICK PANEL
LeftFrontWindow01 LF:DK BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:GRY
RightRearWindow01 RF:TAN LR:PPL RR:PPL
Doorlocks / Windows
Power UnLock
USE 1500 OHM RESISTOR
Convenience
HeadLights BLU (-) (-) HEADLIGHT SWITCH
TrunkRelease BLK /WHT + (+) AT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
