2000 TOYOTA SIENNA MINIVAN
Security
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 RED (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/GRN (-) (-) RED/YEL USE BOTH( BLOCK LEFT OF COLUMN)
TrunkTrigger GRN/WHT (-) (-) BLOCK LEFT OF COLUMN
HoodTrigger BLK (-) (-) PIN UNDER HOOD
FactoryAlarmDisarm BLU (-) 20 PIN PLUG AT FUSE BOX OR DR.KICK PANE
FactoryAlarmArm ARMS WITH LOCK
ParkingLights GRN/SLV DOT (+) BOTTOM RIGHT SIDE OF FUSE BOX
Remote Start
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED (+) + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
KeySense BLU/BLK(-) (-) IGNITION HARNESS
Tach GRAY (-) AT COIL
SpeedSense VIO/YEL AT ECM
ParkingLights GRN/SLV DOT (+) BOTTOM RIGHT SIDE OF FUSE BOX
BrakeLights GRN/WHT (+) (+) AT SWITCH OR WHT 13 WAY PLUG
ReverseLights RED/BLK (+) (+) AT LIGHT
Horn GRN/BLK (-) IGNITION HARNESS
Doorlocks / Window
PowerUnLock BLU/YEL (-) (-) AND BLU/RED FOR CHILD LOCKS DIO ISOLATE*
PowerLock BLU/WHT (-) (-) DRIVERS DOOR HARNESS
DriverDoorMotor01 YEL/BLK (+) DRIVERS KICK PANEL
DriverDoorMotor02 BLU/RED (+) DRIVERS KICK PANEL
PassengerDoorMotor01 BLU DRIVERS KICK PANEL
Convenience
Mobile Audio / Video
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/RED + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
