2000 MAZDA MIATA 2DR CONVERTIBLE
Security
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Starter01 WHT/BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT/RED (-) (-) DRIVERS KICK WHT 2 PIN CONN
TrunkTrigger RED/WHT (-) (-) AT COURTESY LIGHT IN TRUNK
ParkingLights RED/BLK (+) (+) DRIVERS KICK OR RELAY BOX PASS FIREWALL
Remote Start
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Ignition BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRN/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 WHT/BLU + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety VIO (-) PCM PIN 16 PCM ABOVE GAS PEDAL
Tach BRN (-) (-) COIL OR GRN/ORG PCM ABOVE GAS PEDALU
SpeedSense BLK/WHT (AC) ABOVE GAS PEDAL
ParkingLights RED/BLK (+) (+) DRIVERS KICK OR RELAY BOX PASS FIREWALL
BrakeLights GRN (+) (+) AT BRAKE SWITCH
ReverseLights RED/YEL (+) REVERSE LIGHT SWITCH OR LIGHTS
Horn GRN/ORG (-) OR GRN/YEL (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock VIO - (-) DRIVERS KICK PANEL
PowerLock VIO - (-) DRIVERS KICK PANEL *1KOHM RESISTOR
DriverDoorMotor01 LT GRN REV (REV) AT MOTOR IN DOOR
DriverDoorMotor02 RED/YEL REV (REV) AT MOTOR IN DOOR
LeftFrontWindow01 LF:GRN/RED
RightFrontWindow01 LF:WHT/RED
LeftRearWindow01 RF:RED/BLK
RightRearWindow01 RF:RED/GRN
Doorlocks / Windows
PowerLock
USE 1KOHM RESISTOR
Convenience
HeadLights BLK/BLU (+) (+) UNDER LEFT DASH
LowSpeedWipers BLK/WHT (+) AT STEERING COLUMN
Mobile Audio / Video
Battery WHT/RED + (+) IGNITION SWITCH HARNESS
Accessory01 GRN/RED + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
Amp LF. REAR
Control Modules
UNDER LEFT DASH
ECM under right dash Powertrain Control Module PCM
PCM under left dash Transmission Control Module TCM above pedals
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
