2000 HONDA INSIGHT 2DR HATCHBACK
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/RED (-) (-) 16 PIN CONNECTOR UNDER CENTER CONSOLE
TrunkTrigger SHARED WITH DOOR CIRCUIT
FactoryAlarmDisarm OEM REMOTE ONLY
FactoryAlarmArm OEM REMOTE ONLY
ParkingLights RED/BLK (+) (+) 14 PIN GRAY CONN BEHIND DRIVERS DASH
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 WHT/BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/WHT (-) (-) STEERING COLUMN
Tach BLU (AC) (AC) AT ECM
ParkingLights RED/BLK (+) (+) 14 PIN GRAY CONN BEHIND DRIVERS DASH
BrakeLights GRN/WHT (+) (+) AT SWITCH ABOVE BRAKE
ReverseLights GRN/BLK (+) (+) AT SWITH NEAR TRANSMISSION
Horn ORG (-) 14 PIN CONN BEHIND DRIVERS DASH
Doorlocks / Window
PowerUnLock WHT/GRN (-) (-) AT MODULE BEHIND LEFT OF DASH
PowerLock WHT/BLU (-) (-) AT MODULE BEHIND LEFT OF DASH
Convenience
HeadLights BLU/RED (-) (-) AT HEADLIGHT SWITCH
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination RED/BLK + (+) RADIO HARNESS
Dimmer RED + (+) RADIO HARNESS
PowerAntenna WHT/GRN (+) RADIO HARNESS
FrontLeftSpeakerPos GRN/BLK
FrontLeftSpeakerNeg LT GRN
FrontRightSpeakerPos GRN/YEL
FrontRightSpeakerNeg GRAY/RED
RearLeftSpeakerPos BLU/WHT
RearLeftSpeakerNeg BLU/BLK
RearRightSpeakerPos PNK
RearRightSpeakerNeg BLU/YEL
Control Modules
ECM right side of floor right side of floor
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
