2000 FORD TAURUS 4DR WAGON
Security
Battery GRN/BLK + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/BLU (+) (-) DRIVERS KICK PANEL
TrunkTrigger WHT/YEL (-) (-) DRIVER SIDE DASH AT (GEM)
HoodTrigger TAN/LT.GRN(-) (-) PIN 17 AT FACTORY KEYLESS UNIT=GEM
ParkingLights BRN (+) (+) PARKING LIGHT SWITCH
Remote Start
Battery GRN/BLK + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem PATS
Tach TAN/YEL (-) FIREWALL AT (PCM) PIN 48
SpeedSense GRY/BLK (AC) PCM PIN 68 CONN. ON FIREWALL
ParkingLights BRN (+) (+) PARKING LIGHT SWITCH
BrakeLights RED/LT.GRN(+) (+) BRAKE SWITCH
ReverseLights BLK/PNK (+) (+) AT LIGHT OR TRANSMISSION SELECTOR
Horn DK.BLU STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN(-) (-) DRIVERS KICK PANEL
PowerLock PNK/YEL (-) (-) DRIVERS KICK PANEL
DriverDoorMotor01 RED/WHT (+) (+) KICK PANEL DRIVER SIDE
DriverDoorMotor02 PNK/BLK (+) (+) KICK PANEL BOTH SIDES
PassengerDoorMotor01 PNK/ORG (+) KICK PANEL PASS SIDE
LeftFrontWindow01 RF-WHT/YEL
RightFrontWindow01 LR-YEL/LT.BLU)RR-YEL/BLK
LeftRearWindow01 RF-YEL/RED
RightRearWindow01 LR-GRY/ORG)RR-RED/BLK
Convenience
HeadLights RED/YEL (-) (-) HEADLIGHT SWITCH
LowSpeedWipers DK.GRN (+) (+) JUNCTION BOX UNDER DASH
Mobile Audio / Video
Battery GRN/BLK + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ground -
Control Modules
BCM-DRIVERS DASH /GEM-DRIVER DASH
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
