1999 TOYOTA COROLLA 4DR SEDAN
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Starter01 RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) DR. KICK PANEL
TrunkTrigger RED/WHT (-) (-) AT TRUNK LIGHT"WGN WORKS WITH DOME LIGHT
FactoryAlarmDisarm WHT/GRN (-) DRIVERS KICK PANEL
ParkingLights DK GRN (+) (+) LIGHT SWITCH HARNESS OR BOTTOM FUSE BOX
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/BLK (-) (-) STEERING COLUMN HARNESS
Tach RED (-) YEL/GRN COIL PACK TOP OF ENGINE
SpeedSense VIO/WHT 4000 (AC) DR.SIDE OF CONSOLE GRY 22 PIN CONN
ParkingLights DK GRN (+) (+) LIGHT SWITCH HARNESS OR BOTTOM FUSE BOX
BrakeLights GRN/WHT (+) AT BRAKE SWITCH
ReverseLights RED/BLK (+) (+) 18 PIN CONN DR.KICK PANEL
Horn GRN/RED (-) STEERING COLUMN
Doorlocks / Window
PowerUnLock BLU/YEL (-) (-) AND WHT TIE THEM TOGETHER AND DIO ISOLAT
PowerLock LT.BLU/WHT(-) (-) DRIVERS KICK
LeftFrontWindow01 LF:YEL
RightFrontWindow01 RF:GRN/RED LR:RED/GRN RR:RED/BL
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:BLU/WHT LR:BLU/BLK RR:YEL
Convenience
HeadLights RED/WHT (-) (-) AT STEERING COLUMN
TrunkRelease RED (+) REAR HATCH WAGON ONLY
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
