1999 TOYOTA CELICA 2DR CONVERTIBLE
Security
Battery WHT + (+) OR BLK/RED IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK HARNESS RUNNING TO TRUNK
TrunkTrigger BLU/YEL (-) (-) DRIVER'S KICK HARNESS(JUNCTION BLOCK)
ParkingLights DK. GRN (-) (-) AT DIMMER OR FUSEBOX
Remote Start
Battery WHT + (+) OR BLK/RED IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 + RUNS WITH IGNITION
Accessory02 +
Starter01 BLK/YEL (+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense YEL (-) (-) IGNITION SWITCH HARNESS
Tach GRY (AC) CHECK CONN REAR DR SIDE OF ENG
SpeedSense ORG 4000 (AC) PASS CONSOLE 22 PIN POS 9 OR 12 PIN POS1
ParkingLights DK. GRN (-) (-) AT DIMMER OR FUSEBOX
BrakeLights GRN/WHT (+) (+) AT BRAKE SWITCH OR DR. KICK PANEL
ReverseLights RED/WHT (+) (+) 10 PIN GRY PLUG DRIVERS KICK
Horn GRN (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock BLU (-) (-) AND GREEN USE BOTH WIRES DIODE ISOLATE
PowerLock BLU/BLK (-) (-) AT DOOR LOCK MOD "RT OF STEERING COLUMN"
ChildSafetyWire GREEN (-) AT MODULE TO RIGHT OF STEERING COLUMN
LeftFrontWindow01 LF:GRN
RightFrontWindow01 RF:GRN/WHT LF:GRN/WHT RR:GR
LeftRearWindow01 LF:RED
RightRearWindow01 RF:RED/BLU LF:RED/WHT RR:RE
Convenience
HeadLights RED/BLK (-) (-) AT HEADLIGHT SWITCH
Mobile Audio / Video
Battery WHT + (+) OR BLK/RED IGNITION SWITCH HARNESS
Accessory01 + RUNS WITH IGNITION
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
