1999 NISSAN QUEST MINIVAN
Security
Battery WHT/VIO + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGN. HARNESS
Starter01 BLK/YEL + (+) IGN SW HAR *RED/GRN COLD START WIRE*
AllDoorTrigger RED/WHT (-) (-) DRIVER'S KICK OR DASH IND.(DIODE ISOLATE
TrunkTrigger LT.BRN/WHT(-) (-) DRIVER'S KICK "USE DIODE TO ISOLATE"
FactoryAlarmDisarm RED/BLK (-) DRIVERS KICK 16 PIN CONN
ParkingLights PNK/BLU (+) (+) FUSE PNL BEHIND DRIVERS DASH
Remote Start
Battery WHT/VIO + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGN. HARNESS
Ignition02 RED/GRN + (+) OR BLU IGN SWITCH (HEAT/A.C.)
Ignition03 +
Accessory01 WHT/GRN + (+) IGN. HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGN SW HAR *RED/GRN COLD START WIRE*
Starter02 RED/GREEN (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/ORG (-) (-) STEERING COLUMN
Tach GRN/WHT (AC) (AC) IGN. MOD ON ENG.OR PCM PIN 3 GLOVE BOX
SpeedSense GRN/YEL (AC) PASS DASH 88 PIN PLUG AT PCM POS 26
ParkingLights PNK/BLU (+) (+) FUSE PNL BEHIND DRIVERS DASH
BrakeLights YEL/BLK (+) (+) AT SWITCH
ReverseLights BLU/RED (+) (+) SWITCH ON DR. SIDE OF TRANS.
Horn YEL (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock GRN/ORG (-) (-) NEGATIVE DOOR TRIGGER
PowerLock GRN/WHT (-) (-) DRIVER'S KICK PANEL OR CENTER CONSOLE
LeftFrontWindow01 LF:VIO
RightFrontWindow01 RF:GRN/BLK LR:RED/WHT RR:RED
LeftRearWindow01 LF:BLU/RED
RightRearWindow01 RF:ORG/BLU LR:RED/BLK RR:RED/BLU
Convenience
HeadLights GRY/RED (+) LIGHT SWITCH
TrunkRelease N/A
Mobile Audio / Video
Mobile Audio / Video
Battery WHT/VIO + (+) IGN. HARNESS
Accessory01 WHT/GRN + (+) IGN. HARNESS
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
Dimmer (-) RADIO HARNESS
FrontLeftSpeakerPos ORG/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg YELLOW
RearLeftSpeakerPos LT.BRN/WHT
RearLeftSpeakerNeg LT.BRN/YEL
RearRightSpeakerPos LT.BRN/GRN
RearRightSpeakerNeg BRN/PNK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
