1999 MERCURY VILLAGER MINIVAN
Security
Battery WHT/VIO + (+) IGN. HARNESS
Ignition BRN (+) IGN. HARNESS
Starter01 RED + (+) IGN SW HARNESS WHT/BLU STARTER #2
AllDoorTrigger WHT (-) (+) DRIVER'S UNDER DASH LIGHT
TrunkTrigger LT.BRN/WHT(-) (-) CENTER CONSOLE ( DIODE ISOLATE)
HoodTrigger BLK/PNK (-) (-) PIN SWITCH UNDER HOOD
FactoryAlarmDisarm RED/BLK (-) DRIVERS KICK 16 PIN CONN
FactoryAlarmArm W/LOCKS
ParkingLights PNK (+) (+) LIGHT SWITCH HARNESS
Remote Start
Battery WHT/VIO + (+) IGN. HARNESS
Ignition BRN (+) IGN. HARNESS
Ignition02 +
Ignition03 +
Accessory01 RED/GRN + (+) OR BLU IGN SWITCH (HEAT/A.C.)
Accessory02 +
Starter01 RED + (+) IGN SW HARNESS WHT/BLU STARTER #2
Starter02 WHITE/BLUE (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense BLU/ORG (-) (-) STEERING COLUMN
Tach GRN/WHT (AC) (AC) IGN. MOD ON ENG.OR PCM PIN 3 GLOVE BOX
SpeedSense GRN/YEL (AC) PASS DASH 88 PIN PLUG AT PCM POS 26
ParkingLights PNK (+) (+) LIGHT SWITCH HARNESS
BrakeLights YEL/BLK (+) (+) AT SWITCH
ReverseLights BLU/RED (+) (+) SWITCH ON DR. SIDE OF TRANS.
Horn YEL (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock RED/BLK (+) (+) POSITVE DOOR TRIGGER
PowerLock RED (+) (+) 10 PIN CONN DRIVERS DOOR BOOT
DriverDoorMotor01 WHT/GRN (+) LEFT KICK PANEL
DriverDoorMotor02 GRN/YEL (+) LEFT KICK PANEL
PassengerDoorMotor01 WHT/RED RIGHT KICK PANEL
LeftFrontWindow01 LF:VIO
RightFrontWindow01 RF:GRN/BLK LR:RED/WHT RR:RED
LeftRearWindow01 LF:BLU/RED
RightRearWindow01 RF:ORG/BLU LR:RED/BLK RR:RED/BLU
Convenience
HeadLights GRY/RED (+) LIGHT SWITCH
TrunkRelease N/A
Mobile Audio / Video
Battery WHT/VIO + (+) IGN. HARNESS
Accessory01 RED/GRN + (+) OR BLU IGN SWITCH (HEAT/A.C.)
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
FrontLeftSpeakerPos ORG/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos LT.BRN/WHT
RearLeftSpeakerNeg LT.BRN/YEL
RearRightSpeakerPos LT.BRN/GRN
RearRightSpeakerNeg BRN/PNK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
