1999 LEXUS RX300 4DR SUV
Security
Battery WHT + (+) WHT/BLU IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS (HEATER)
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (-) LEFT OF STEERING BLK 13 PIN CONN POS 2
TrunkTrigger WHT/RED (-) (-) DRIVERS KICK 20 PIN CONN LOW IN PANEL
HoodTrigger RED/BLU (-) (-) ENGINE UNDER RELAY BOX DR. SIDE GRY PLUG
FactoryAlarmDisarm W/LOCKS
FactoryAlarmArm W/LOCKS
ParkingLights GRN (+) (+) BACK OF FUSE BOX 11 PIN PLUG
Remote Start
Battery WHT + (+) WHT/BLU IGNITION SWITCH HARNESS
Ignition BLK/YEL (+) IGNITION SWITCH HARNESS (HEATER)
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 PNK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach ORG (-) RIGHT OF FUSE BOX IN 20 PIN PLUG
SpeedSense VIO/WHT (AC) PIN 12 AT CCM IN DRIVERS KICK PANEL
ParkingLights GRN (+) (+) BACK OF FUSE BOX 11 PIN PLUG
BrakeLights GRN/WHT (-) (-) 12 WAY PLUG IN DRIVERS KICK PANEL PIN 9
Horn WHT/RED (-) STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/BLU (-) (-) (AND GRY) IN PASS. DOOR "SEE NOTE"
PowerLock PNK (-) (-) HARNESS BETWEEN MODULE AND DOOR ACTUATOR
LeftFrontWindow01 LF:RED
RightFrontWindow01 RF:RED LR:RED RR:RED
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:GRN LR:GRN RR:GRN
Convenience
HeadLights RED/BLU (-) (-) STEERING COLUMN
LowSpeedWipers BLU/BLK (+) (+) OR BLU/RED STEERING COLUMN
Mobile Audio / Video
Battery WHT + (+) WHT/BLU IGNITION SWITCH HARNESS
Accessory01 PNK + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN/WHT + (+) RADIO HARNESS
PowerAntenna BLK/RED (+) RADIO HARNESS
AMPTurnOn GRAY (+) RADIO HARNESS
FrontLeftSpeakerPos YEL
FrontLeftSpeakerNeg BLK
FrontRightSpeakerPos RED
FrontRightSpeakerNeg BLUE
Amp LFT REAR CARGO AREA
Control Modules
IN DRIVERS KICK PANEL
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
