1999 JEEP WRANGLER 2DR SUV
Security
Battery PNK/BLU + (+) OR RED IGN HARNESS OR FUSEBOX UNDER HOOD
Ignition BLU (+) IGN HARNESS OR FUSEBOX UNDER HOOD
Starter01 YEL (+) + (+) IGN HARNESS OR FUSEBOX UNDER HOOD
AllDoorTrigger YEL (-) (-) 14 PIN GRY CONN DRIVERS KICK PANEL
TrunkTrigger N/A COMMON WITH DOORS
ParkingLights BLK/YEL (+) (+) DOOR SWITCH OR BLK/WHT COURTESY LIGHT
Remote Start
Battery PNK/BLU + (+) OR RED IGN HARNESS OR FUSEBOX UNDER HOOD
Ignition BLU (+) IGN HARNESS OR FUSEBOX UNDER HOOD
Ignition02 BLK/ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION HARNESS
Accessory02 +
Starter01 YEL (+) + (+) IGN HARNESS OR FUSEBOX UNDER HOOD
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem SENTRY-KEY
KeySense LT.BLU (-) (-) IGNITION SWITCH HARNESS
NeutralSafety BRN/LT. BLU (-) BLK 32 PIN CONN AT PCM
Tach GRY/WHT (-) (-) OR GRY (-) AT COIL
SpeedSense WHT/ORG (AC) WIRE HARNESS FROM TRANSMISSION
ParkingLights BLK/YEL (+) (+) DOOR SWITCH OR BLK/WHT COURTESY LIGHT
BrakeLights WHT/TAN (+) (+) AT BRAKE SWITCH OR WHT AT HAZARD SWITCH
ReverseLights VIO (+) (+) DRIVER'S KICK
Horn RED/YEL (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock N/A
PowerLock N/A
LeftFrontWindow01 N/A
LeftRearWindow01 N/A
Convenience
HeadLights LT.GRN (+) (+) AT LIGHT SWITCH
LowSpeedWipers GRY (+) (+) AT WIPER SWITCH
TrunkRelease N/A
Mobile Audio / Video
Battery PNK/BLU + (+) OR RED IGN HARNESS OR FUSEBOX UNDER HOOD
Accessory01 BLK/ORG + (+) IGNITION HARNESS
Ground CHASSIS -
Illumination ORG (+) RADIO HARNESS
Dimmer BLK/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos BRN/RED
FrontLeftSpeakerNeg GRN
FrontRightSpeakerPos BLU
FrontRightSpeakerNeg VIOLET
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/BLU
RearRightSpeakerPos BLU/WHT
RearRightSpeakerNeg BLU/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
