1999 INFINITI Q45 4DR SEDAN
Security
Battery WHT/GRN (+) (+) IGNITION HARNESS
Ignition BLK/RED (+) (+) IGNITION HARNESS
Starter01 BLK/WHT (+) (+) IGNITION HARNESS
AllDoorTrigger 4 SEP WIRES (-) BCM RIGHT OF COLUMN SEE NOTE
TrunkTrigger YEL (-) BCM ,RIGHT OF STEERING COLUMN
HoodTrigger BRN (-) (-) AT BCM RIGHT OF COLUMN
FactoryAlarmDisarm W/LOCKS DISARM WITH LOCKS
FactoryAlarmArm W/LOCKS
ParkingLights RED/GRN (+) (+) LOW IN DRIVERS KICK PANEL
Remote Start
Battery WHT/GRN (+) (+) IGNITION HARNESS
Ignition BLK/RED (+) (+) IGNITION HARNESS
Ignition02 +
Ignition03 +
Accessory01 WHT/BLU + (+) IGNITION HARNESS
Accessory02 +
Starter01 BLK/WHT (+) (+) IGNITION HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach WHT/GRN (-) ECM PASS KICK PANEL
SpeedSense PNK/BLU (AC) PIN 7 AT CCM LEFT OF STEERING COLUMN
ParkingLights RED/GRN (+) (+) LOW IN DRIVERS KICK PANEL
BrakeLights RED (+) (+) LOW IN THE DRIVERS KICK PANEL
Horn GRN/RED STEERING COLUMN
Doorlocks / Window
PowerUnLock VIO (-) (-) NEGATIVE TRIGGER
PowerLock ORG (-) (-) DRIVERS DOOR SWITCH
DriverDoorMotor01 YEL (+) IN DRIVER'S DOOR
DriverDoorMotor02 WHT (+) IN DRIVER'S DOOR
PassengerDoorMotor01 YEL IN DRIVER'S DOOR
LeftFrontWindow01 LF:BLU/RED
RightFrontWindow01 RF:BLU/RED LR:BLU/RED RR:BLU/RED EACH
LeftRearWindow01 LF:BLU/BLK
RightRearWindow01 RF:BLU/BLK LR:BLU/BLK RR:BLU/BLK SWITCH
Convenience
HeadLights GRY/YEL (-) AND YEL/BLK HIGH CURRENT NEGATIVE
LowSpeedWipers BLU/RED (-) (-) STEERING COLUMN
TrunkRelease VIO (-) (-) HIGH CURRENT NEGATIVE DRIVERS KICK
Mobile Audio / Video
Battery WHT/GRN (+) (+) IGNITION HARNESS
Accessory01 WHT/BLU + (+) IGNITION HARNESS
Ground -
Amp RIGHT SIDE OF TRUNK
Control Modules
RIGHT OF THE STEERING COLUMN
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
