1999 DODGE VIPER 2DR CONVERTIBLE
Security
Battery RED + (+) IGN SWITCH OR RED/WHT ALARM MOD
Ignition DK.BLU (+) IGNITION SWITCH OR DK.BLU/WHT ALARM MOD
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) HEADLIGHT SWITCH OR ALARM MODULE
TrunkTrigger GRY/BLK (-) (-) LIGHT IN TRUNK
FactoryAlarmDisarm LT.GRN/ORG(-) AT OEM ALARM DRIVER'S SIDE TRANS TUNNEL
FactoryAlarmArm YEL/BLK (+) ALARM MODULE
ParkingLights BLK/YEL (+) (+) HEADLIGHT SWITCH OR ALARM MODULE
Remote Start
Battery RED + (+) IGN SWITCH OR RED/WHT ALARM MOD
Ignition DK.BLU (+) IGNITION SWITCH OR DK.BLU/WHT ALARM MOD
Ignition02 BLK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK/GRY (-) LEFT OF IGNITION COIL PACK
ParkingLights BLK/YEL (+) (+) HEADLIGHT SWITCH OR ALARM MODULE
BrakeLights VIO/BLK (+) (+) AT BRAKE SWITCH
ReverseLights WHT (+) (+) SWITCH ON TRANSMISSION
Horn BLK/RED (-) AT STEERING COLUMN OR ALARM MOD
Doorlocks / Window
PowerUnLock PNK/WHT (+) POSITIVE TRIGGER
PowerLock WHT/DK.GRN (+) DRIVERS DOOR BOOT
Convenience
HeadLights LT.GRN (+) (+) AT LIGHT SWITCH
LowSpeedWipers GRN/WHT (-) (-) AND RED/YEL(-)AT STEERING COLUMN"GRY PLG
Mobile Audio / Video
Battery RED + (+) IGN SWITCH OR RED/WHT ALARM MOD
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination ORG (+) RADIO HARNESS
Dimmer BLK/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos LT.GRN/VIO
FrontLeftSpeakerNeg LT.GRN/GRN
FrontRightSpeakerPos LT.BLU/VIO
FrontRightSpeakerNeg LIGHT BLUE/GREEN
RearLeftSpeakerPos WHT/VIO
RearLeftSpeakerNeg WHT/DK.GRN
RearRightSpeakerPos TAN/VIO
RearRightSpeakerNeg TAN/GRN
Amp NOT LIKELY
Control Modules
DR.SIDE OF CONSOLE "SEE NOTE"
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
