1999 CHEVROLET VAN VAN
Security
Battery RED (+) (+) OR RED/WHT IGNITION HARNESS
Ignition PNK (+) (+) IGNITION HARNESS
Starter01 YEL (+) (+) IGNITION HARNESS
AllDoorTrigger VIO (-) (-) PIN SWITCH OR HEADLIGHT SWITCH
TrunkTrigger ORG/BLK (-) SAME AS DOME LIGHT
ParkingLights BRN (+) (+) HEADLIGHT SWITCH
Remote Start
Battery RED (+) (+) OR RED/WHT IGNITION HARNESS
Ignition PNK (+) (+) IGNITION HARNESS
Ignition02 PNK/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 WHT + IGNITION SWITCH HARNES
Accessory01 ORG + (+) IGNITION HARNESS
Accessory02 +
Starter01 YEL (+) (+) IGNITION HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK II
KeySense LT.GRN (-) (-) IGNITION SWITCH HARNESS
Tach WHT (-) DR. INNER FENDER LOCATED IN BLK PLUG
SpeedSense GRN/WHT 4000 (AC) DRIV FENDER WALL BLK 32 PIN CONN POS3
ParkingLights BRN (+) (+) HEADLIGHT SWITCH
BrakeLights WHT (+) (+) ABOVE BRAKE SWITCH
ReverseLights LT.GRN (+) (+) SWITCH ON TRANSMISSION
Horn BLK (-) ABOVE IGNITION HARNESS
Doorlocks / Window
PowerUnLock WHT (+) (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) (+) DRIVERS KICKPANEL LARGE MOLEX
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU
LeftRearWindow01 LF:DK.BRN
RightRearWindow01 RF:TAN
Convenience
HeadLights YEL (+) (+) AT SWITCH
LowSpeedWipers BRN (+) (+) STEERING COLUMN
Mobile Audio / Video
Battery RED (+) (+) OR RED/WHT IGNITION HARNESS
Accessory01 ORG + (+) IGNITION HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer GRY (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
DRIVERS FENDER UNDER HOOD
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
