1999 BMW Z3 2DR CONVERTIBLE
Security
Battery RED/YEL OR + (+) RED IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) (-) FROM DOOR STRIKER TO PLG @ REAR OF RUNNE
TrunkTrigger BRN/WHT (-) (-) 12 PIN PLUG BEHIND GLOVE BOX
ParkingLights GRY/YEL L (+) GRY/VIO R AT LIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/VIOLET-DIODE ISOLATE
Remote Start
Battery RED/YEL OR + (+) RED IGNITION SWITCH HARNESS
Ignition GRN (+) IGNITION SWITCH HARNESS
Ignition02 VIO/WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem EWS II
Tach BLK (-) BEHIND INST.CLUSTER NEAR LIGHT SWITCH
SpeedSense BLK/WHT (AC) PIN 10 AT RADIO HARNESS
ParkingLights GRY/YEL L (+) GRY/VIO R AT LIGHT SWITCH
BrakeLights RED/BLU (+) (+) SWITCH ABOVE BRAKE PEDAL
Doorlocks / Window
PowerUnLock BLU/RED (+) (+) GLOVE BOX. HARNESS RUNS ALONG FIREWALL.
PowerLock WHT/RED (+) (+) AT Z-V MODULE ABOVE 2 OTHER MODULES BEH.
LeftFrontWindow01 LF:BLK
RightFrontWindow01 RF:BLK/GRY
LeftRearWindow01 LF:BLK
RightRearWindow01 RF:VIO/GRY
Convenience
Mobile Audio / Video
Battery RED/YEL OR + (+) RED IGNITION SWITCH HARNESS
Accessory01 VIO + (+) IGNITION SWITCH HARNESS
Ground BROWN - (-) RADIO HARNESS
Illumination GRY/RED (+) RADIO HARNESS
PowerAntenna WHT (+) RADIO HARNESS
FrontLeftSpeakerPos YEL/RED
FrontLeftSpeakerNeg YEL/BRN
FrontRightSpeakerPos BRN/BLK
FrontRightSpeakerNeg BLUE/BROWN
RearLeftSpeakerPos BLU/BLK
RearLeftSpeakerNeg YEL/BRN
RearRightSpeakerPos BLU/VIO
RearRightSpeakerNeg BLU/GRY
Amp RT SIDE OF TRUNK
Control Modules
FACTORY ALARM PLUG BEHIND GLOVE BOX
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
