1999 AUDI A6 4DR SEDAN
Security
Battery RED/WHT + (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
Ignition BLU (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
Starter01 RED/BLK (+) + (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
AllDoorTrigger RED/YEL (+) (-) DRIVER'S SIDE PILLAR HARNESS
TrunkTrigger WHT/YEL (-) (-) HARNESS FROM TRUNK LID
FactoryAlarmDisarm BRN/GRN (-) DRIVERS KICK PANEL
ParkingLights GRY/WHT L (+) AND GRY/YEL R BEHIND FUSE BLOCK DIODE IS
Security
Parking Lights
ALSO (+) GRAY/YELLOW-DIODE ISOLATE
Remote Start
Battery RED/WHT + (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
Ignition BLU (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
Ignition02 PPL + (+) IGNITION SWITCH HARNESS
Ignition03 GRN + IGNITION SWITCH HARNESS
Accessory01 YEL/BLK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/BLK (+) + (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
AntiTheftSystem NONE
Tach GRY/GRN (AC) COIL PACK ON TOP OF ENGINE UNDER COVER
SpeedSense WHT/BLU (AC) PIN A1 AT RADIO HARNESS
ParkingLights GRY/WHT L (+) AND GRY/YEL R BEHIND FUSE BLOCK DIODE IS
BrakeLights RED/BLK (+) (+) SWITCH ABOVE BRAKE PEDAL
Doorlocks / Window
PowerUnLock BRN/YEL (-) (-) DOUBLE PULSE TO UNLOCK ,DISARM ALARM
PowerLock GRN/BLU (-) (-) TAN CONN DRIVERS KICK NEGATIVE TRIGGER
LeftFrontWindow01 LF:WHT/VIO
RightFrontWindow01 RF:WHT LR:YEL/BLK RR:GRN/YEL
LeftRearWindow01 LF:WHT/BLK
RightRearWindow01 RF:BLK/GRN LR: YEL RR:WHT/BLK
Doorlocks / Windows
Power UnLock
REQUIRES DOUBLE PULSE
Convenience
TrunkRelease N/A
Mobile Audio / Video
Battery RED/WHT + (+) IGN SWITCH OR LEFT OF COLUMN RELAY BANK
Accessory01 YEL/BLK + (+) IGNITION SWITCH HARNESS
Ground -
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
