1998 VOLKSWAGEN BEETLE 2DR COUPE
Security
Battery RED + (+) IGNITION HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK(+) + (+) ALSO BLU 2ND STARTER (THIN WIRE)
AllDoorTrigger BRN/WHT (-) (-) IN EACH DOOR(OR BRN/YEL DR. DASH "DELAY"
TrunkTrigger BRN/BLK (-) (-) TRUNK LIGHT
FactoryAlarmDisarm BLK/BLU IGN POWER FOR FACTORY ALARM OPEN W/RELAY
ParkingLights GRY/VIO (+) (+) LIGHT SWITCH HARNESS
Security
Parking Lights
ALSO (+) GRAY/YELLOW-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 BLU + (+) STARTER 2 WIRE IGNITION HARNESS
Ignition03 GLO PLUG + BLU/GRN REAR OF CLUSTER FOR DIESEL BUGS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/BLK(+) + (+) ALSO BLU 2ND STARTER (THIN WIRE)
Starter02 BLUE (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach GRN/BRN (-) ON PLUG FROM INST CLUSTER
SpeedSense WHT/BLU (AC) PIN A1 AT RADIO HARNESS
ParkingLights GRY/VIO (+) (+) LIGHT SWITCH HARNESS
BrakeLights RED/BLK (+) (+) AT BRAKE SWITCH
Doorlocks / Window
PowerUnLock WHT/LT.GRN(-) (-) NEGATIVE NEED 2 PULSE TO DISARM ALARM
PowerLock YEL/LT.BLU(-) (-) IN DRIVERS DOOR MULTIPLEX LOCKS
Convenience
TrunkRelease BRN/VIO (-) (-) RELAY UNDER DASH MARKED WITH A 79 ON IT
Mobile Audio / Video
Battery RED + (+) IGNITION HARNESS
Accessory01 BLK/RED + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU (+) RADIO HARNESS
PowerAntenna RED/WHT (+) RADIO HARNESS
FrontLeftSpeakerPos BLU/WHT
FrontLeftSpeakerNeg BRN/WHT
FrontRightSpeakerPos RED
FrontRightSpeakerNeg BROWN/RED
RearLeftSpeakerPos RED/GRN
RearLeftSpeakerNeg BRN/GRN
RearRightSpeakerPos LT.BLU
RearRightSpeakerNeg BRN/LT.BLU
Control Modules
TO LEFT OF STEERING COLUMN
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
