1998 HONDA ACCORD 2DR COUPE
Security
Battery WHT + (+) PASSENGER SIDE FUSE BOX OR IGN HARNESS
Ignition BLK/YEL (+) PASSENGER SIDE FUSE BOX OR IGN HARNESS
Starter01 BLK/WHT + (+) AT HEATER AC FAN MOTOR
AllDoorTrigger BLK/WHT (-) (-) PASSENGER SIDE FUSE BOX
TrunkTrigger ORG (-) (-) DRIVERS KICK GREY MOLEX PLUG
HoodTrigger YEL (-) (-) PASS SIDE GRN PLUG
FactoryAlarmDisarm BLU DRIVERS DOOR
FactoryAlarmArm BLU/WHT DRIVERS DOOR
ParkingLights RED/BLK (+) FUSE BOX
Remote Start
Battery WHT + (+) PASSENGER SIDE FUSE BOX OR IGN HARNESS
Ignition BLK/YEL (+) PASSENGER SIDE FUSE BOX OR IGN HARNESS
Ignition02 WHT/BLK + (+) IGNITION SWITCH HARNESS (ABS LIGHT)
Ignition03 +
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/WHT + (+) AT HEATER AC FAN MOTOR
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem TRANSPONDER
Tach BLU (-) AT DIST OR PASS SIDE FIREWALL
SpeedSense BLU/WHT (AC) ECM,CENT.CONSOLE,GRY 32 PIN PLUG,PIN 3
ParkingLights RED/BLK (+) FUSE BOX
BrakeLights GRN/WHT (+) (+) AT BRAKE SWITCH
ReverseLights GRN/BLK (+) (+)
Horn LT GRN/BLU PASSENGER SIDE FUSE BOX
Doorlocks / Window
PowerUnLock ORG (-) NEGATIVE TRIGGER
PowerLock BLK/BLU (-) OR BLK/RED PANEL PASS SIDE NEAR DOOR
Convenience
HeadLights BLU (+) LEFT OF COLUMN "BLU PLUG"
LowSpeedWipers BLU(-)
TrunkRelease WHT/RED (+) (+) DRIVERS SIDE GREY MOLEX
Mobile Audio / Video
Battery WHT + (+) PASSENGER SIDE FUSE BOX OR IGN HARNESS
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Dimmer RED/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos BLU/GRN
FrontLeftSpeakerNeg GRY/BLK
FrontRightSpeakerPos RED/GRN
FrontRightSpeakerNeg BROWN/BLACK
RearLeftSpeakerPos BLU/YEL
RearLeftSpeakerNeg GRY/WHT
RearRightSpeakerPos RED/YEL
RearRightSpeakerNeg BRN/WHT
Amp IF BOSE AT EACH SPK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
