1998 DODGE AVENGER 2DR COUPE
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/GRN (-) DR.KICK OR BLK 19 PIN CONN ON BACK OF FU
TrunkTrigger RED/GRN (-) (-) AT TRUNK LIGHT
FactoryAlarmDisarm LT.GRN/ORG DR.DOOR BOOT OR GRN/WHT DR.KICK PANEL
ParkingLights GRN/WHT (+) 18 PIN CONN AT FUSEBOX
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU/BLK + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense GRN/YEL (-) (-) STEERING COLUMN HARNESS
NeutralSafety BLK/YEL (-) (-) SWITCH DR. SIDE OF TRANSMISSION
Tach BRN (-) (-) COIL PACK (WHT PIN 73 AT 80 PIN PCM
SpeedSense WHT/ORG 8000 (AC) GRY 40 PIN CONN POS 66 DRIVERS FRONT QTR
ParkingLights GRN/WHT (+) 18 PIN CONN AT FUSEBOX
BrakeLights GRN (+) (+) AT BRAKE SWITCH
ReverseLights RED/BLU (+) (+) 20 PIN CONN AT FUSE BOX
Horn GRN/BLK (-) AT STEERING COLUMN "WHT 3 PIN PLUG"
Doorlocks / Window
PowerUnLock BRN (-) (-) NEGATIVE TRIGGER
PowerLock BRN/WHT (-) (-) DRIVER'S KICK PANEL OR RELAY BELOW RADIO
LeftFrontWindow01 LF:GRN/RED
RightFrontWindow01 RF:BRN/YEL MAIN
LeftRearWindow01 LF:GRN/BLK
RightRearWindow01 RF:GRN/YEL SWITCH
Convenience
HeadLights RED (-) AT LIGHT SWITCH ORSTEERING COLUMN HARNES
LowSpeedWipers BLK/WHT (+) AT STEERING COLUMN
TrunkRelease N/A
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLU/BLK + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination ORG/BRN (+) RADIO HARNESS
Dimmer BLK/GRN (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg BRN/RED
FrontRightSpeakerPos VIO
FrontRightSpeakerNeg BLUE/RED
RearLeftSpeakerPos BRN/YEK
RearLeftSpeakerNeg BRN/BLU
RearRightSpeakerPos BLU/WHT
RearRightSpeakerNeg BLU/ORG
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
