1998 CHEVROLET VENTURE MINIVAN
Security
Battery RED (2) + (+) IGNITION HARNESS ONE IS 60 AMP AND 40 AM
Ignition PNK (+) IGNITION HARNESS
Starter01 YEL + (+) IGNITION HARNESS
AllDoorTrigger TAN/DK.BLU(-) (+) ORG DIODE ISOLATE PASS KICK BCM USE ALL3
TrunkTrigger WORKS WITH DOME LIGHT
FactoryAlarmDisarm ORG/BLK (-) 16 PIN CONN DR KICK PANEL
ParkingLights BRN (+) (+) FIREWALL CONNECTOR LOWER LEFT PANEL
Remote Start
Battery RED (2) + (+) IGNITION HARNESS ONE IS 60 AMP AND 40 AM
Ignition PNK (+) IGNITION HARNESS
Ignition02 WHT + (+) IGNITION HARNESS
Ignition03 BRN + IGNITION HARNESS
Accessory01 ORG + (+) IGNITION HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) 48 PIN CONN BASE OF STEERING COLUMN
Tach WHT (-) PCM LEFT SIDE OF ENG IN AIR CLEANER
SpeedSense GRN/WHT (AC) DRIV.SHOCK TOWER.10 PIN PLUG,PIN K
ParkingLights BRN (+) (+) FIREWALL CONNECTOR LOWER LEFT PANEL
BrakeLights WHT (+) (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) 56 PIN CONN LEFT OF STEERING COLUMN
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (-) (-) 10 PIN PLUG NEGATIVE TRIGGER
PowerLock LT.BLU (-) (-) DRIVERS KICK PANEL
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers PNK (+) AT SWITCH
TrunkRelease GRY/BLK (-)
Mobile Audio / Video
Battery RED (2) + (+) IGNITION HARNESS ONE IS 60 AMP AND 40 AM
Accessory01 ORG + (+) IGNITION HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
