1998 CHEVROLET TAHOE 2DR SUV
Security
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL (+) IGNITION SWITCH HARNESS
AllDoorTrigger VIO (-) EITHER PIN SWITCH
TrunkTrigger PPL (-) 4 PIN BLK CONN DR.KICK PANEL
FactoryAlarmDisarm TAN KEYLESS ENTRY RIGHT OF COLUMN
ParkingLights BRN (+) HEADLIGHT SWITCH
Remote Start
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGNITION SWITCH HARNESS
Ignition03 BRN + IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK II
KeySense LT.GRN (-) (-) IGNITION SWITCH HARNESS
Tach WHT (-) (-) AT COIL PASS REAR OF ENGINE
SpeedSense DK.GRN/WHT (AC) PIN 15 AT RADIO HARNESS OR PIN K CCM
ParkingLights BRN (+) HEADLIGHT SWITCH
BrakeLights WHT (+) (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) MODULE AT LEFT SIDE OF DRIVERS DASH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) ABOVE GAS PEDEL AT FACTORY RELAYS
LeftFrontWindow01 FL:BLU
RightFrontWindow01 FR:LT.BLU,RL:GRN,RR:LT.GRN
(DOOR SWITCH)
LeftRearWindow01 FL:BRN
RightRearWindow01 FR:TAN,RL:VIO,RR:VIO
Convenience
HeadLights YEL (+) (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT STEERING COLUMN
TrunkRelease BRN (+) AT SWITCH OR DRIVER'S KICK PANEL
Mobile Audio / Video
Battery RED (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp UNDER DRIVERS SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
