1998 CHEVROLET MALIBU 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS *REMOVE RADIO *
Ignition PNK (+) IGNITION SWITCH HARNESS *TO GET AT *
Starter01 YEL + (+) IGNITION SWITCH HARNESS *IGNITION HARN*
AllDoorTrigger LT.GRN/BLK L (-) DRV KICK, LT.BLU(-) R DRIV KICK "ISOLATE
TrunkTrigger ORG/BLK (-) (-) TRUNK LIGHT
ParkingLights BRN (+) (+) GRY BOOT AT FIREWALL
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS *REMOVE RADIO *
Ignition PNK (+) IGNITION SWITCH HARNESS *TO GET AT *
Ignition02 GRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS *IGNITION HARN*
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK II
KeySense LT.GRN (-) STEERING COLUMN HARNESS
NeutralSafety YEL (-) (-) DR.SIDE ELECTRICAL CENTER
Tach VIO/WHT (AC) TOP OF MOTOR AT COIL
SpeedSense GRN/WHT (AC) DRIVERS KICK PAN. 80 PIN PLUG (C NOTE)
ParkingLights BRN (+) (+) GRY BOOT AT FIREWALL
BrakeLights WHT (+) (+) SWITCH ABOVE BRAKE PEDAL
ReverseLights LT.GRN (+) (+) 18 PIN CONN BEHIND DRIVERS DASH
Horn BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT + (+) PASSENGER SWITCH IS MASTER SWITCH
PowerLock LT.BLU + (+) DRIVERS KICK PANEL POSITIVE TRIGGER
LeftFrontWindow01 LF:DK BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:PPL RR:PPL
Convenience
HeadLights BLU (-) (-) HEADLIGHT SWITCH
TrunkRelease BLK (+) DRIVER KICK PANEL OR AT SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS *REMOVE RADIO *
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
