1998 BUICK SKYLARK 4DR SEDAN
Security
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/BLK(-) L (-) DRV KICK, LT.BLU(-) R PASS KICK"ISOLATE"
TrunkTrigger ORG/BLK (-) (-) LIGHT SWITCH
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVERS KICK
Remote Start
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGN SW "MUST ENERGIZE TO REMOTE START"
Ignition03 BRN + IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) STEERING COLUMN
NeutralSafety ORG/BLK (-) (-) DR.DASH TO LEFT OF COLUMN
Tach WHT (-) OR VIO/WHT PCM BEHIND PASS DASH
SpeedSense DK GRN (AC) PCM,PASS SIDE DASH,BLU.PIN PLUG,PIN55
ParkingLights BRN (+) AT LIGHT SWITCH OR DRIVERS KICK
BrakeLights LT.BLU (+) (+) AT SWITCH ABOVE BRAKE
ReverseLights LT.GRN (+) PASS KICK
Horn BLK (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO
Convenience
HeadLights YEL (+) (+) AT HEADLIGHT SWITCH
TrunkRelease BLK (+) (+) KEYLESS MODULE IN TRUNK
Mobile Audio / Video
Battery RED (2) + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
