1997 VOLKSWAGEN CABRIO 2DR CONVERTIBLE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) (-) FACTORY SECURITY MOD.BELOW LIGHT SWITCH
TrunkTrigger BRN/BLK (-) (-) FACTORY SECURITY MOD.BELOW LIGHT SWITCH
HoodTrigger BRN/RED (-) (-) FACTORY SECURITY MOD.BELOW LIGHT SWITCH
FactoryAlarmDisarm W/UNLOCK WIRE
FactoryAlarmArm W/LOCK WIRE
ParkingLights GRY/RED AND (+) GRY/BLK LIGHT SWITCH HARNESS(INDEPENDENT
Security
Parking Lights
ALSO (+) GRAY/BLACK-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach BLK/RED OR (AC) GRN COIL ON FIREWALL
ParkingLights GRY/RED AND (+) GRY/BLK LIGHT SWITCH HARNESS(INDEPENDENT
BrakeLights RED/BLK (+) SWITCH ABOVE BRAKE PEDAL
Doorlocks / Window
PowerUnLock GRY (+) (+) FACTORY SECURITY MOD.BELOW LIGHT SWITCH
PowerLock GRN (+) (+) FACTORY SECURITY MOD.BELOW LIGHT SWITCH
Doorlocks / Windows
Power UnLock
REQUIRES DOUBLE PULSE
Convenience
TrunkRelease GRY/WHT OR (+) GRY RELEASE SWITCH IN DASH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos BLU/BLK
FrontLeftSpeakerNeg ORG/BLK
FrontRightSpeakerPos RED/WHT
FrontRightSpeakerNeg ORANGE/WHITE
RearLeftSpeakerPos RED/LT.GRN
RearLeftSpeakerNeg ORG/BLK
RearRightSpeakerPos BLU/LT.GRN
RearRightSpeakerNeg ORG/RED
Amp IF AMPED AT EACH SPK
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
