1997 TOYOTA TERCEL 2DR COUPE
Security
Battery WHT + (+) BLK/RED IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (+) 2 PIN CONN AT FUSE BOX DRIVERS KICK PANE
TrunkTrigger RED/YEL (-) (-) AT LIGHT IN TRUNK
FactoryAlarmDisarm WHT/BLU (-) 10 PIN CONN DRIVERS KICK PANEL
ParkingLights GRN (+) (+) 11 PIN GRY CONN AT FUSE BOX
Remote Start
Battery WHT + (+) BLK/RED IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) STEERING COLUMN
Tach BLK/BLU (AC) BLU 12 PIN CONN PASS KICK PANEL
SpeedSense YEL (AC) ECM,BEH.GLOVE,12 PIN PLUG PIN 11
ParkingLights GRN (+) (+) 11 PIN GRY CONN AT FUSE BOX
BrakeLights RED/WHT (+) (+) AT SWITCH ABOVE BRAKE
ReverseLights RED/BLK (+) (+) BLU 12 PIN CONN PASS KICK PANEL
Horn GRN/YEL (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock GRN/YEL (-) NEGATIVE DOOR LOCKS
PowerLock RED/YEL (-) 10 PIN CONN DRIVERS KICK PANEL
LeftFrontWindow01 LF:RED
RightFrontWindow01 RF:BLU/RED LR:GRN/RED RR:GRN/BLK AT SWIT
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:BLU/YEL LR:BLU RR:BLU/BL
Convenience
HeadLights RED/BLU (-) (-) AT HEADLIGHT SWITCH
Mobile Audio / Video
Battery WHT + (+) BLK/RED IGNITION SWITCH HARNESS
Accessory01 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRN (+) RADIO HARNESS
FrontLeftSpeakerPos PNK
FrontLeftSpeakerNeg VIO
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg BLUE
RearLeftSpeakerPos BLK
RearLeftSpeakerNeg YEL
RearRightSpeakerPos RED
RearRightSpeakerNeg WHT
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
