1997 SUBARU OUTBACK 4DR WAGON
Security
Battery BLK/YEL + (+) IGNITION SWITCH HARNESS
Ignition RED (+) IGNITION SWITCH HARNESS
Starter01 BLU/RED + (+) IGNITION SWITCH HARNESS
AllDoorTrigger RED/WHT (-) (+) DRIVER'S KICK PANEL
TrunkTrigger YEL/BLU (-) (-) DRIVER'S KICK PANEL
FactoryAlarmDisarm WHT/GRN (-) DRIVERS KICKPANEL(GRN/YEL FACTORY ARM)
ParkingLights WHT/GRN (+) DRIVER'S KICK "GRY PLUG TEST W/KEY ON"
Remote Start
Battery BLK/YEL + (+) IGNITION SWITCH HARNESS
Ignition RED (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 RED/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLU/RED + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense `
Tach BLU (-) (-) COIL OR RED WIRE AT ECM PASS FLOOR POS 6
SpeedSense GRN/BLK (AC) ECM,PASS KICK,12 PIN PLUG,PIN 11
ParkingLights WHT/GRN (+) DRIVER'S KICK "GRY PLUG TEST W/KEY ON"
BrakeLights WHT/BLK (+) DRIVERS KICK OR AT BRAKE SWITCH
Horn RED/BLU AT HORN RELAY IN DRIVER'S KICK
Doorlocks / Window
PowerUnLock WHT (-) (-) NEGATIVE TRIGGER
PowerLock WHT/RED (-) (-) DRIVERS KICKPANEL
LeftFrontWindow01 LF:BLU/RED
RightFrontWindow01 RF:RED/BLK LR:GRN/BLK RR:GRN/WHT
LeftRearWindow01 LF:BLU
RightRearWindow01 RF:BLK/BLU LR:GRN/YEL RR:BLU/WHT
Convenience
HeadLights BLU/BLK (-) (-) AT LIGHT SWITCH
Mobile Audio / Video
Battery BLK/YEL + (+) IGNITION SWITCH HARNESS
Accessory01 RED/YEL + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination RED (+) RADIO HARNESS
FrontLeftSpeakerPos YEL
FrontLeftSpeakerNeg BLU/RED
FrontRightSpeakerPos WHT
FrontRightSpeakerNeg BLUE/BLACK
RearLeftSpeakerPos YEL/WHT
RearLeftSpeakerNeg BLU/RED
RearRightSpeakerPos WHT/BLU
RearRightSpeakerNeg BLU/BLK
Amp NOT LIKELY
Control Modules
ECM UNDER PASSENGER SEAT
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
