1997 PONTIAC TRANSPORT MINIVAN
Security
Battery RED + (+) RED/WHT IGNITION HARNESS
Ignition PNK (+) IGNITION HARNESS
Starter01 YEL + (+) IGNITION HARNESS
AllDoorTrigger VIO (-) (-) LIGHT SWITCH
TrunkTrigger GRY/BLK (-) (-) BODY CONTROL MODULE PASS DASH DIODE ISOL
FactoryAlarmDisarm PNK (-) SWITCH:(FACT DISARM ORG/BLK DR.KICK 16PI
ParkingLights BRN (+) (+) FIREWALL CONNECTOR
Remote Start
Battery RED + (+) RED/WHT IGNITION HARNESS
Ignition PNK (+) IGNITION HARNESS
Ignition02 WHT + (+) IGNITION HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION HARNESS
AntiTheftSystem NONE
KeySense LT.GRN (-) (-) 48 PIN CONN BASE OF STEERING COLUMN
Tach WHT (-) HARNESS LEFT SIDE OF ENGINE TOP MANIFOLD
SpeedSense GRN 4000 (AC) DR.FRONT QTR BLU 80 PIN CONN POS 13
ParkingLights BRN (+) (+) FIREWALL CONNECTOR
BrakeLights WHT (+) (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) 56 PIN CONN LEFT OF STEERING COLUMN
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (-) (-) 10 PIN PLUG
PowerLock LT.BLU (-) (-) DRIVERS KICK PANEL
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers PNK (+) AT SWITCH
TrunkRelease GRY/BLK (-)
Mobile Audio / Video
Battery RED + (+) RED/WHT IGNITION HARNESS
Accessory01 ORG + (+) IGNITION HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
