1997 OLDSMOBILE ACHIEVA 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/BLK(-) L (-) DRV KICK, LT.BLU(-) R PASS KICK"ISOLATE"
TrunkTrigger ORG/BLK (-) (-) LIGHT IN TRUNK
ParkingLights BRN (+) AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGN SW "MUST ENERGIZE TO REMOTE START"
Ignition03 BRN + IGN SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSLOCK
KeySense LT.GRN (-) (-) STEERING COLUMN HARNESS
Tach WHT (-) PCM BEHIND PASS DASH ABOVE KICK PANEL
SpeedSense GRN (AC) PASS DASH BLU 80 PIN CONN POS 13
ParkingLights BRN (+) AT LIGHT SWITCH
BrakeLights LT/BLU (+) AT BRAKE SWITCH
ReverseLights LT.GRN (+) (+) SWITCH ON DR.SDIE OF TRANS.
Horn BLK
Doorlocks / Window
PowerUnLock WHT (+) POSITIVE TRIGGER
PowerLock LT.BLU (+) DRIVER'S KICK "AT DOORLOCK RELAYS"
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:LT.BLU LR:DK.GRN RR:LT.GRN
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN LR:VIO RR:VIO
Convenience
HeadLights YEL (+) (+) HEADLIGHT SWITCH
TrunkRelease BLK/WHT (+) KEYLESS MODULE DR. SIDE OF TRUNK
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS (HEAT/A.C.)
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
