1997 MITSUBISHI MONTERO 4DR SUV
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRN/RED (-) (-) FRONT FUSEPANEL 12 PIN CONN POS 8
TrunkTrigger SAME AS DOME LIGHT
ParkingLights GRN/WHT (+) FRONT OF FUSEPANEL 2 PIN CONN
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/RED + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense GRN/YEL (-) (-) IGNITION SWITCH HARNESS
Tach WHT (-) ECM PASSENGERS KICK PANEL
SpeedSense YEL/WHT (AC) DATA LINK UNDER DRIVER'S SIDE DASH
ParkingLights GRN/WHT (+) FRONT OF FUSEPANEL 2 PIN CONN
BrakeLights GRN (+) (+) AT SWITCH
ReverseLights RED/BLU (+) (+) 32 PIN CONN DRIVERS KICK PANEL
Horn GRN/BLK 3 PIN CONN STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK/BLU (-) (-) NEGATIVE TRIGGER
PowerLock BLK/RED (-) (-) REAR FUSEPANEL 8 PIN CONN PIN 27
LeftFrontWindow01 LF:RED
RightFrontWindow01 RF:RED/BLU LR:RED/WHT RR:RED/WHT
LeftRearWindow01 LF:GRN
RightRearWindow01 RF:BLK/YEL LR:GRN/WHT RR:GRN/WHT
Convenience
HeadLights RED/BLU AT HL RELAY DRV FENDER BEHIND BATTERY
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Ground -
Illumination GRN/WHT (+) RADIO HARNESS
Dimmer BLK/YEL (+) RADIO HARNESS
PowerAntenna WHT/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
