1997 MERCURY MOUNTAINEER 4DR SUV
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition GRN/VIO (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) DRIVER'S KICK PANEL OR LIGHT SWITCH
TrunkTrigger N/A WORKS WITH DOME LIGHT
FactoryAlarmDisarm DK.GRN/VIO(-) DRIVER'S KICK PANEL
ParkingLights WHT/BLK (+) AT SWITCH OR BRN DRIVERS KICK
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition GRN/VIO (+) IGNITION SWITCH HARNESS
Ignition02 GRY/YEL + (+) IGNITION SWITCH HARNESS (2ND ACCESSORY)
Ignition03 +
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem PATS
KeySense BLK/PNK (-) (-) IGNITION SWITCH HARNESS
Tach TAN/YEL (AC) (AC) AT TEST CONN. DRIVER'S FENDER.
ParkingLights WHT/BLK (+) AT SWITCH OR BRN DRIVERS KICK
BrakeLights GRN (+) (+) AT BRAKE SWITCH
ReverseLights BLK/PNK (+) (+) SWITCH ON TRANSMISSION
Horn YEL/LT.GRN STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/GRN (-) (-) W/OUT KEYLESS REV POLARITY SAME LOCATION
PowerLock PNK/YEL (-) (-) DRIVER'S KICK PANEL NEGATIVE TRIGGER
LeftFrontWindow01 LF:WHT/BLK
RightFrontWindow01 RF:WHT/YELRR:YEL/BLK LR:GRY/ORG
LeftRearWindow01 LF:RED
RightRearWindow01 RF:TAN/LT.BLU RR:RED/BLK LR:YEL/LT.BLU
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
LowSpeedWipers WHT LOW (+) BLU/ORN HIGH AT WIPER MOTOR
TrunkRelease N/A
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination LT.BLU/RED (+) RADIO HARNESS
PowerAntenna AMP=BLU
FrontLeftSpeakerPos ORG/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos GRY/LT.BLU
RearLeftSpeakerNeg TAN/YEL
RearRightSpeakerPos BRN/PNK
RearRightSpeakerNeg ORG/RED
Amp REAR RIGHT PANEL
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
