1997 MAZDA PROTEGE 4DR SEDAN
Security
Battery BLK (2) + (+) IGN. HARNESS
Ignition BLU/WHT (+) IGN. HARNESS
Starter01 BLK/BLU + (+) IGN. HARNESS
AllDoorTrigger BLK/RED (-) (-) DRIVER'S KICK PANEL
TrunkTrigger BLU (-) (-) LIGHT IN TRUNK
ParkingLights RED/BLK (+) (+) DRIVER'S KICK PANEL
Remote Start
Battery BLK (2) + (+) IGN. HARNESS
Ignition BLU/WHT (+) IGN. HARNESS
Ignition02 BLK/YEL + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/RED + (+) IGN. HARNESS
Accessory02 +
Starter01 BLK/BLU + (+) IGN. HARNESS
AntiTheftSystem NONE
KeySense WHT (+) (+) IGNITION SWITCH HARNESS
Tach VIO/GRN (AC) (AC) AT COIL: WHT BELOW ECM CENTER CONSOLE
SpeedSense GRN/RED (AC) ECM,CENT.CONSOLE,22 PIN PLUG
ParkingLights RED/BLK (+) (+) DRIVER'S KICK PANEL
BrakeLights GRN/YEL (+) (+) AT SWITCH
ReverseLights RED/YEL (+) (+) SWITCH ON TRANSAXLE
Horn GRN/ORG (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock WHT/BLU (-) PASSENGER KICK PANEL
PowerLock WHT/BLU (-) PASSENGER KICK PANEL
LeftFrontWindow01 LF:RED/BLK
RightFrontWindow01 RF:GRN/WHT LR:RED/GRN RR:BLU/BLK
LeftRearWindow01 LF:YEL/WHT
RightRearWindow01 RF:GRY LR:WHT/GRN RRGRY/BLK
Doorlocks / Windows
PowerLock
USE 4.7KOHM RESISTOR
Convenience
HeadLights RED/WHT LOW (+) WHT/BLU HIGH AT HEADLIGHT SWITCH
HeadLightsHi WHITE/BLUE (+) AT VEHICLE LIGHT SWITCH
Mobile Audio / Video
Mobile Audio / Video
Battery BLK (2) + (+) IGN. HARNESS
Accessory01 BLK/RED + (+) IGN. HARNESS
Ground BLK/YEL - (-) RADIO HARNESS
Illumination RED/BLK (+) RADIO HARNESS
Dimmer N/A
FrontLeftSpeakerPos VIO
FrontLeftSpeakerNeg BLU/ORG
FrontRightSpeakerPos YEL/BLU
FrontRightSpeakerNeg VIOLET/WHITE
RearLeftSpeakerPos YEL
RearLeftSpeakerNeg ORG
RearRightSpeakerPos GRN/ORG
RearRightSpeakerNeg GRN/BLK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
