1997 ISUZU HOMBRE 2DR PICKUP
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger WHT (-) (-) COURTESY LIGHT UNDER DASH
TrunkTrigger COMMON WITH DOORS
FactoryAlarmDisarm N/A
ParkingLights BRN (+) LIGHT SWITCH OR DRIVERS KICK
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 WHT + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT GRN (-) STEERING COLUMN HARNESS
Tach WHT (-) (-) AT COIL
SpeedSense GRN/WHT 4000 (AC) PASS FRT QTR BLK 80 PIN CONN POS 16
ParkingLights BRN (+) LIGHT SWITCH OR DRIVERS KICK
BrakeLights WHT (+) AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (REV) WITH KEYLESS POSITIVE
PowerLock LT.BLU (REV) DRIVERS KICK PANEL 5 WIRE WITH OUT KEY
LeftFrontWindow01 LF:BLU
RightFrontWindow01 RF:BLU/WHT, AT SWITCH
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:TAN, AT SWITCH
Doorlocks / Windows
Power UnLock
(+) ON MODELS WITH KEYLESS
PowerLock
(+) ON MODELS WITH KEYLESS
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT LIGHT SWITCH
TrunkRelease N/A
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
