1997 CHEVROLET TAHOE 2DR SUV
Security
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL (+) IGNITION SWITCH HARNESS
AllDoorTrigger PPL (-) AT DRIVERS PINSWITCH
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm TAN KEYLESS ENTRY RIGHT OF COLUMN
ParkingLights BRN (+) LIGHT SWITCH HARNESS
Remote Start
Battery RED (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 PNK/WHT + (+) IGNITION SWITCH HARNESS "SEE TECH TIP"
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach WHT (-) (-) COIL OR E.C.M.DRIVERS FENDER BLACK PLUG
SpeedSense DK.GRN/WHT (AC) PIN 15 AT RADIO HARNESS OR PIN K CCM
ParkingLights BRN (+) LIGHT SWITCH HARNESS
BrakeLights WHT (+) AT BRAKE SWITCH OR DRIVERS KICK PANEL
ReverseLights LT GRN(+) (+) AT CONVENIENCE CENTER MODULE
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock WHT (+) (+) RELAY ABOVE GAS PEDAL
PowerLock LT.BLU (+) (+) WITHOUT KEYLESS ENTRY SHOULD BE 5-WIRE.
LeftFrontWindow01 FL:BLU
RightFrontWindow01 FR:LT.BLU,RL:GRN,RR:LT.GRN
(DOOR SWITCH)
LeftRearWindow01 FL:BRN
RightRearWindow01 FR:TAN,RL:VIO,RR:VIO
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT STEERING COLUMN
TrunkRelease BLK(+) (+) AT SWITCH OR DRIVER'S KICK PANEL
Mobile Audio / Video
Mobile Audio / Video
Battery RED (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
