1997 CHEVROLET CORVETTE 2DR CONVERTIBLE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger GRY/BLK (-) (-) BCM BEHIND DRIVERS DASH
TrunkTrigger HATCH RELEASE SWITCH
FactoryAlarmDisarm LT.GRN (-) INSIDE DRIVERS DOOR
ParkingLights BRN (+) DRIVER'S KICK OR AT LIGHT SWITCH
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSKEY
KeySense GRN/BLK (-) (-) IGNITION SWITCH HARNESS
Tach WHT (-) PCM PASS SIDE ENG COMP BELOW BATTERY
ParkingLights BRN (+) DRIVER'S KICK OR AT LIGHT SWITCH
BrakeLights WHT OR LT.BLU (+) SWITCH ON BRAKE PEDAL ARM
ReverseLights LT.GRN (+) (+) UNDERHOOD ELECTRICAL CENTER
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock RED/BLK (-) (-) NEGATIVE TRIGGER
PowerLock ORG/BLK (-) (-) DRIVER'S DOOR ONLY DATA LINK LOCKS
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:DK.BLU
LeftRearWindow01 LF:BRN
RightRearWindow01 RF:BRN
Convenience
HeadLights WHT (+) (+) AT LIGHT SWITCH
TrunkRelease BLK (+) (+) HATCH RELEASE SWITCH
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer BRN (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp BEHIND PASS. SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
